15:02
máy tính nguyên vũ
An ideal construction without the interference between channels is obtained by having a monophonic stream composition, and an electrical properties and a linearity are also good and make sound of a pure Class-A still more beautiful.
A changeover of a switchpoint realizes quality AB class 120 W/ch of a switching distortion and crossover distorted relative minimum a high speed high fT transistor and on the basis of an original Low-TIM design.
Furthermore, the stream composition of a platform also determines a tone quality as a first priority, and consideration of sound is carried out even to the detail.
As for the power meter, conventional not a bar graphical representation but light emitting diode are indicating the output by the point.
The high-speed response type protection network where a thermal sensor detects the temperature of a heat sink directly is adopted.
A selection of AC amplifier and DC amplifier can be performed, moreover it does not pass along SW but few gilding direct input terminals of a tone-quality failure are carried.
The power switch and the gain control are stored to the traditional sub panel.
| Form | Monophonic power amplifier |
| Output power (20Hz - 20kHz) |
120W (at the time of 8 ohms and AB class
drive) 150W (at the time of 4 ohms and AB class drive) 30W (at the time of 8 ohms and a pure Class-A drive) |
| THD | 0.01% (8 ohms, 20Hz - 20kHz) |
| Cross modulation distortion | 0.01% |
| Frequency characteristic | 20Hz-20kHz:+0, -0.2dB + 0, -1 dB:DC-100kHz |
| Input sensitivity/impedance | 1.5V/30kohm |
| Dumping factor | 100 (8-ohm load intensity) or more |
| Remains noise (IHF-A curve) | 0.034mV |
| Power dissipation | Electrical Appliance and Material Control Law: 150W |
| Power source | 100V, 50/60Hz |
| Dimensions | Width 208x height 146x depth of 334mm |
| Weight | 10kg |
Posted in: 
0 nhận xét:
Post a Comment